![]() If one of your Trax’s door speakers isn’t working, the most common location of the short will be where the harness enters the door (since it moves).2018 Chevy Trax transmission services offered by Bill Estes Chevy Indianapolis: It’s more likely to be caused by a damaged speaker wire. But, you’d likely hear a static sound from the speaker. One of my Chevy Trax’s speakers isn’t working. You can check to see if any of the fuses in your vehicle have blown, and if they haven’t, then you should look for loose or corroded wiring in your electrical system. If it does, then there may be an issue with the wiring or the radio itself (wiring short, blown fuse, no power, and ground connection). No, your Chevy Trax’s radio should not stop working when you are in a car accident. In this case, you should take your Trax to a professional for repair or replacement.Ĭommon Questions Does the radio stop working when you crash? If it works, then there is likely an issue with the radio itself. You can test this by attempting to connect another device, such as an iPod, to the car’s audio system. If your Trax has a CD player or aux button and it was recently touched, then your radio may be stuck in that mode. ![]() Cause 3: CD Player or Aux Button Has Been Touched Here are all the ways you can look up your Trax’s radio code. If that doesn’t work, you can take it to the dealer and have them pull it. Some manufacturers will let you look it up online if you need the code. Sometimes it’s printed on the back of the owner’s manual. Most vehicles come with a card where the number is recorded or written inside the glove box on a sticker. If your vehicle’s stereo is coming on and says to “input radio code, ” you’ll need to find. If you suspect this might be the problem, check to see if your vehicle’s antenna is in good working condition (is it bolted on?). Antennas are reliable, but they can weaken and eventually break entirely over time, mainly if you frequently utilize drive-through car washes. The CD player or Aux input should still work fine.Ī broken antenna is one of the most common issues that cause your Trax’s radio to stop working. ![]() When the tuner is on, there will be static. The Radio is On But No Sound Cause 1: Broken Antenna If there’s power going to your Trax’s radio, and you’ve verified that the ground connection is good and it has power, the only way to get your car working is to repair or replace it. Any issue with the wiring harness will prevent power from getting to the radio system and cause the fuse to blow again. ![]() Use a multimeter to verify the voltage level is accurate. Verify that your vehicle’s radio has a solid ground connection. If your Trax’s radio fuse checks out, it’s time to determine if there’s a problem with the wiring harness going to the radio system. If both sides light up, the fuse is fine. If it only lights up for one prong, the fuse has failed, and you’ll need to replace it. Next, turn the key to the accessory position, and touch the test light tip to both prongs. You can usually find one inside the door jam that will reach the fuse box. Start by finding a good ground source on your Trax to ground the test light to. Here’s how: Touch each of these prongs with a test light. This can be accomplished without even pulling a fuse. If the connecting filament is damaged, power can’t reach the head unit, and the fuse needs to be replaced.Ī better way to verify a fuse is functioning is to use a test light. First, you can visually inspect your Trax’s radio fuse. You should see a schematic printed on the door. Step 2: Once you access your vehicle’s fuse box, you’ll need to locate the radio fuse. On most makes and models, it’s to the left of the driver’s seat (when you are behind the steering wheel). Step 1: You’ll need to your Chevy Trax’s fuse box location.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |